Hip-to-gable and dormer loft conversions: party wall notices
A hip-to-gable or dormer conversion usually needs a party wall notice, but not because of the dormer or the gable itself. A notice is triggered by what the project does to the wall between you and your neighbour: raising it, cutting pockets in it for steel beams, flashing into it or taking down a shared chimney. Those are section 2 rights, and they need a party structure notice at least two months ahead (section 3).
Our general loft conversion party wall guide covers the basics. This page deals with what is different about dormers and hip-to-gable roofs.
What the Act does and does not care about
A dormer built entirely on your own roof slope, and a new gable wall on your own side, are not party wall work. The Act applies to party walls, party fence walls and party structures (section 20), and to excavation near neighbours' buildings. So the question is always the same: where does the structure meet the shared wall?
On a typical semi, the party wall runs up through the loft to the roof. The conversion changes how that wall is used, so it usually becomes the busiest part of the job.
Hip-to-gable: which side are you changing?
Hip-to-gable replaces a sloping hip end with a vertical gable wall, to gain floor area.
- Hip on the outer flank, away from the neighbour. This is the common semi case. The new gable stands on your own external wall. The gable itself is usually not a party wall job, though the loft conversion around it may well be.
- Hip at the party wall. Where your roof hips back toward the shared wall, the work may involve raising the party wall to meet the new roof line. That is section 2(2)(a) (raise a party structure), and a two-month notice.
- End-of-terrace and detached houses. The flank wall is your own external wall. If there is no shared wall, the Act has little to bite on, although a neighbouring building within the excavation distances can still trigger section 6.
Hip-to-gable also tends to move the chimney. If the stack sits at the party wall, you will probably be deciding between carrying the neighbour's flues up and removing it. The rules for that are in our chimney breast removal guide. In short, cutting away a breast or flue from a party wall is section 2(2)(g); taking down a shared stack and rebuilding it is section 2(2)(e). If you remove it, you usually have to carry the neighbour's flues up in suitable materials, as the supporting subsections of section 2 describe.
Dormers and the party wall
Roof dormers, particularly rear box dormers across a semi, load the structure differently from the original roof. The steelwork often needs a bearing on or in the party wall.
| Element | Typical effect on the party wall | Likely right |
|---|---|---|
| Steel purlin or ridge beam bearing in a pocket | Cutting into the wall | s.2(2)(f) |
| Padstone or new masonry inserted in the party wall | Cutting into and loading the wall | s.2(2)(f) |
| Party wall raised to the new roof line or to form an upstand | Raising the wall | s.2(2)(a) |
| Lead flashing or soaker chased into the wall beside the dormer cheek | Cutting in | s.2(2)(f) |
| Dormer cheek built wholly on your slope, with no contact | None | None |
| Replacing the roof covering on your slope | None | None |
The dormer's position matters. Planning rules often keep a dormer back from the roof edge, so some dormers never touch the party wall. If the structure is clear of the wall and carries no bearing into it, you may need no notice for the dormer itself. What decides it is whether any steel, timber or flashing meets the shared wall, and the engineer's drawings answer that.
Steels into the wall
Steel into a party wall is the single most common reason a loft needs a notice. Two things to know.
First, the rights are in section 2(2)(f), cutting into a party structure for any purpose, so the size of the beam makes no difference. A small pocket needs the same two months as a large one.
Second, the neighbour can serve a counter notice within a month (section 4) asking for certain additions, such as chimney copings or breasts, if they will not harm you or cause unnecessary delay. The detail on beam bearings is in our RSJ guide.
Notice checklist
- Obtain structural drawings that show every bearing, pocket and raised wall.
- List each element against a right in the table above.
- Serve a party structure notice on the owner of each affected house. For a semi, that is one neighbour; for a mid-terrace it is two.
- State the work and start date and attach the drawings (section 3(1)).
- Allow two months. Notices lapse if work does not start within twelve months (section 3(2)(b)).
- Record the condition of both lofts and ceilings below.
- Plan the scaffold; if it needs the neighbour's land, give 14 days' written notice (section 8).
Typical sequence
- Planning or lawful development certificate and building regulations are dealt with in parallel. They are separate from the Act.
- Serve notice, with drawings.
- Fourteen days for consent. Silence is treated as dissent, which creates a dispute (section 5).
- Appoint one agreed surveyor or two (section 10). The award sets out the works, working hours, protection and condition records.
- Appeal is possible to the county court within 14 days of service.
- Work begins after the notice period. Protect the neighbour's loft and ceilings. Compensation for damage is required by section 7(2).
What it costs
Use loft figures. HomeOwners Alliance (quoting Checkatrade) gives about £900 to £1,200 for an agreed surveyor and £1,800 to £2,400 for two. BookaBuilderUK gives about £800 to £1,500 for an agreed surveyor, and £1,800 to £3,000 where the neighbour appoints their own. Where the neighbour consents in writing, BestBuilders puts notices at about £50 to £150 each. These are indicative and sources differ. Mid-terrace work doubles the number of neighbours, and BestBuilders notes that fees stack. The building owner normally pays reasonable fees (section 10(13)).
Common mistakes
- Assuming a hip-to-gable on the outer flank means no notice at all, when the same project cuts steels into the party wall.
- Treating chimney removal as internal work and leaving the stack out of the notice.
- Serving the notice with no structural drawings.
- Forgetting the neighbour on the second side of a mid-terrace.
- Starting the roof strip before the two months have run.
Frequently asked questions
Does a hip-to-gable loft conversion need a party wall notice?
Often, but not for the gable alone. A gable on your own outer wall is not party wall work. A notice arises if you raise the party wall, cut steel pockets into it, flash into it or alter a shared chimney stack.
Do I need a party wall notice for a rear dormer?
Only if some part of it touches the shared wall, such as a beam bearing, raised upstand or flashing. A dormer fully on your own slope, clear of the wall, usually needs none. Your engineer's drawings show which applies.
I live in a semi. How many neighbours must I notify?
One, for the shared party wall. If you are also building an extension and digging near another neighbour's building, that owner may need a section 6 notice too.
Can my neighbour stop me raising the wall?
No. Section 2 gives you the right. They can dissent, so surveyors settle how it is done, and they can serve a counter notice within a month, but they cannot refuse the right itself.
Does removing the chimney on a semi need a notice?
If the stack or breast is part of the party wall or serves both houses, yes, usually. If it stands wholly on your side and serves only you, perhaps not. Who the chimney serves decides it.
Related guides
See the home extension guide if the loft is part of a larger scheme, and party wall roofing works for parapets and flashings in detail.
Last updated: 4 November 2026. This page is general information about the Party Wall etc. Act 1996 (England and Wales). It is not legal advice. Every property and dispute is different, so take advice from a party wall surveyor or a solicitor before you act.
Download the Party Wall etc. Act 1996 free
Get the full, up-to-date text of the Act as a PDF from the official legislation.gov.uk record, with our plain-English guide to every section, sent straight to your inbox.
We use your email to send the Act. See our privacy notice.